Overview
This article explains how iGuide measures square footage, how you can use iGuide measurements, and how room areas and totals are calculated. iGuide follows industry-recognized standards, including Alberta’s Residential Measurement Standard (RMS) and ANSI Z765. This gives you consistent, reliable data and a defensible basis for comparing iGuide measurements against other sources.
In this Article
Measurement Accuracy in iGuide
Measurement accuracy in iGuide refers to the high level of precision used to calculate square footage and other property dimensions. iGuide follows the Alberta RMS, adapted from the ANSI Z765-2013 standard. This is among the most comprehensive measurement protocols in North America.
The iGuide laser-based camera system has a margin of error of about 1% for square footage. This meets or exceeds the 2% uncertainty allowed by both the RMS and ANSI standards. All measurements are standardized and legally defensible, making iGuide data a trusted source in real estate transactions.
Use Cases for iGuide Measurements
iGuide measurements support a range of professional use cases:
- Accurate residential measurements: Real estate professionals in Alberta rely on iGuide to comply with RMS. This keeps measurements consistent across complex properties such as condos and multi-family units.
- Visual identification of Gross Living Area (GLA): iGuide floor plans show finished (included) spaces in colour and unfinished or excluded areas in white. This makes it easy to see what counts toward GLA.
- GLA reporting based on ANSI Z765: GLA is equivalent to Finished Above Grade area. You can view it clearly in imperial PDF floor plans.
Important Notes
Keep these points in mind when reviewing iGuide measurements:
- Room height rules apply: Finished rooms must have a minimum floor-to-ceiling height of 7 ft (2.1 m). Rooms with sloped ceilings are included only if the ceiling exceeds 7 ft in at least one spot, measured from 5 ft (1.5 m).
- Perimeter wall thickness is measured once: It’s usually measured at the main entrance and isn’t adjusted for variations around the property.
- Room areas won’t add up to the total square footage: The property details section shows dimensions for major rooms only, measured paint-to-paint. Total floor area includes all floor plans except non-habitable or excluded spaces. Rounding may also cause a difference of about 1 sq ft.
- Width × length is accurate only for rectangular rooms: Most rooms have more complex shapes, so iGuide uses precise measurements rather than length × width.
Frequently Asked Questions
Q: How accurate are iGuide square footage measurements?
A: iGuide has a margin of error of about 1% for square footage. This meets or exceeds the 2% uncertainty allowed by the RMS and ANSI standards.
Q: Which measurement standards does iGuide follow?
A: iGuide follows the Alberta RMS, which is adapted from the ANSI Z765-2013 standard.
Q: Why are some rooms shown in white on the floor plan?
A: White indicates excluded or non-reported areas. This could be due to unfinished space, insufficient ceiling height, or space that is open to below.
Q: Why don’t my room areas add up to the total square footage?
A: Room dimensions are shown for major rooms only and are measured paint-to-paint. Total floor area includes all floor plans except non-habitable or excluded spaces, and rounding may add a difference of about 1 sq ft.
Q: Why weren’t room dimensions included for all rooms?
A: Only major rooms show dimensions. Minor rooms, such as foyers and closets, are hidden to keep the floor plan clear, but this data is available in the iGuide Portal.
Q: Can iGuide accommodate varying wall thicknesses?
A: No. Wall thickness is measured once and applied uniformly. It doesn’t adjust for variations around the property.
Q: Are iGuide measurements BOMA or SIOR certified?
A: No. We only draft within the ANSI Z765 or RMS standards. For other measurement standards, you can derive area measurements from the floor plans or DXF files.